Nilight - TL-01 6" Oval Red LED Tail 2PCS w/Surface Mount Grommets Plugs IP65 Waterproof Stop Brake Turn Trailer Lights for RV Truck Jeep

I bought these to replace the same size lights as I refurbished my 6x12 cargo/motorcycle trailer. Easy to install in existing slots. Perfect fit. Very bright. Much improved over the original lights. So much so, I bought the same style lights again, only in clear, for backup/reverse lights on the same trailer. Had to cut two new slots in back of steel trailer which was no easy task. Suggest laying out and cutting a sample slot on a piece of scrap metal before cutting into your trailer. I found that a 2-5/8in dia hole saw created a better fit for the grommet and the light - instead of the recommended 2-1/2 in dia hole. Slot height was 6-5/8in which worked out well. Used an angle grinder with a cutting wheel for cutting the sides of the oval cutouts between the two holes. Installation of the light into the grommet was made easier with the use of a little '3-in-1' oil on the inside periphery of the grommet. Electrical connections were made using crimped Ancor butt connectors with heatshrink ends. Made for a nice installation. Very bright, high visibility LED lights. Reliable. Highly recommend. Would definitely buy these again.UPDATE 1/25/2021: The red and white (clear) lights are a little different. I expected them to be the same. The grommets for the red lights are from a harder rubber/plastic and are a little more difficult to install than the white ones. The grommet also has a more shiny gloss-like finish. I reminded myself this is a 'cargo trailer', not a Mercedes. Also the housings for the electrical plugs on the back of each light are slightly different between the red and white lights. While they 'will fit' one another ... the fit is much better if paired with the correct light. Also, I applied a little Ox-Gard to the electrical connectors to prevent oxidation and keep out contaminants. Stay well.

fit perfectly, simple wiring, works great

I had to modify (cut back) the plastic around the terminals for old wire harness plugs to fit . 10 minute job.Work great.

Nice and bright. Rubber is a little smaller than the original but works well. Plugged directly into my wiring harness.

refreshed boat trailer ans now can pop these out and replace with ease yearly if needed. i think it ess the blinker with brake that dimmed a bit. i would buy and will buy again. no instructions but bot to hard to figure out

The media could not be loaded. I bought these to replace the huge, garish trapezoidal directionals on a new CSC SG 250 (basically a Chinese clone of the Honda GL 250 series motorcycle.) Anyway, these directionals are very discreet, yet very bright. I had to fabricate some stalks to get them to stick out far enough to be seen by motorists in front or in back of the bike. But I was able to do this with other hardware parts from Amazon. The front two were plug and play , the back ones needed to have the leads extended.

Fits as it should. Nice looking addition to the bike.

I love Nilight. I got these for my father dump trailer. They installed easy and wired up no problems. But when I popped them in they are loose in the holes. Not so bad they fall out but alot looser than I like. It maybe I should I have measured or got exact replacement but I usually dont have a issue. They do look nice and are nice and bright.