Bogar Tech Designs - Precut Side Fender Vent American Flag Vinyl Decal Compatible with Jeep Wrangler JL 2018-2022 and Gladiator 2020-2022, Matte Black

These decals went on very easy and they look great. I put them on with a wet method. I use Windex with out ammonia. I see a lot of dry method applications on u-tube but I think it is more difficult to use. I always pre fit the decal before starting. I clean the site. Wet it down with windex, then peel the bottom paper off wetting as I peel. I place it were I want it. I gently work out the air bubbles with my fingers and if needed a small squeegee. I have found it is best to leave it alone for 2 hours or more to make sure it is dry. Patience pays off most of the time. When it is dry the top paper peels right off if removed carefully. There are several ways to do it. I have not had any issues using this method. I wait a week before I use the car wash.

Like all decals, they can be a hassle. If you make a 1/5th dish soap to water mix, and keep the fender wet, you can move this around all you want. When you get it in place, them push the water out with a credit card and let it dry for about an hour. The problem with the wet method is that it is more difficult to remove the top layer without pulling off the sticker. So I pulled both the sticky and back sides off of the bottom three stripes and placed them individually by hand on the wet surface. Good quality and good cut.

Great item. I was nervous when I saw it arrive in a cardboard envelope but it wasn’t damaged at all and I immediately put it on the Jeep. Took about 30 min for both between prep/clean and installation. East install and looks great! Before and after pictures included.

Went on easily. Only took about 15 mins. Lined up nice and already getting compliments

Finally installed these and it is a nice subtle clean look for our granite crystal Jeep. The directions in the description aren't really the best. Basically we just removed the back paper completely and lined up the side closest to vent first, checking stripes are level and worked our way outward. My son and I did it together to keep one side from sticking to early if that makes sense. It's basically a sticker except there isn't anything in between the stripes once you remove the transfer tape so the paint is exposed. I was hoping it was more like a vinyl cling so if you wanted to remove it, it would be easier to do that. Not sure if that would be a clean look though.

These sticker really look great on our Silver Gladiator. Easy to install, arrived right in time, good quality product. Best if all it's made in the states.

Good quality vinyl decals. Easy to install with decent instructions. I recommend using a little soapy water spray to position it and an old credit card to squeegee out the bubbles.

Love these!! Adds a clean, patriotic look without being overbearing. Pretty easy to install. Looks great and get lots of compliments on them! Put them on my 2021 Jeep Rubicon JL & it’s a perfect fit!