WATERWICH 6-Switch Pod Toggle Panel Overhead and Source Control System Box Wiring Harness Kit With 12 Covers & Clip Remover Compatible With Jeep Wrangle (Red)

The media could not be loaded.  How could it be any easier to add a multi switch interface? On the 2015 jeep wrangler Sahara unlimited there are a few things to note. You may need to buy an extra fastener or two to accommodate the new power and ground. Also, the switch comes with Phillips head screws which were not able to be tightened due to the clearance issues. No worries, just hit up your local hardware place and get hex head machine screws. Other than that the installation COULD NOT have been an easier. The convenient terminals are easy to add new things to (winch, more and more lights). Even the wires to run into the cab to the switches was perfectly cut. It really worked out well and got me the cool look I was looking for.

Only issue I had is I couldn't use this to switch on or off accessories that uses its own power supply

I absolutely love it! My only complaint is the switch panel mounting could use a little better bracket , clamp or way to attach to Jeep ring. Overall it’s definitely worth the money! The actual box under the hood to wire too is top notch & in a great location!

Liked everything and only took about 40 minutes to install , I did put two screws in switch panel to help hold it better. I’m just not sure if I like how the switch panel stays on at all times lit up but I’ll see if it drains battery or not before I put it on another power source . I did mount left side a little lower to give more room for latching top on.

A very poor design. I bought it for my 08 Rubicon. The cutout for the top mount of the switch pod is cut to the left of center and the passenger side visor is useless. Why they manufacturer didn't put the cutout on center is beyond me. I will have to modify the housing which I shouldn't have to.The under-hood design is outstanding. That fits perfectly.

Alright, this think looks clean but the instructions are trash and the fitment is okay with some heavy alterations. It doesn’t come with instructions on installing the head switch unit at all. I looked online at different brands to figure it out. You’re going to have to make one cut in the overhead panel for the main male-female connection.I had to drill two holes as shown in my photos to securely connect the unit to the plastic overhead. It comes with a very thin strip of 3m tape that honestly won’t hold at all and will leave gaps all around.The top bracket that holds the screw requires removal of the top and the angel to screw it down to the metal clip is rough. It took a while.Honestly like the final result but it’s not a simple plug and play when it comes to the switch box.Decent all around.

Works great and easy to install. The only draw back is that it will not stay in place. The tape provided didn’t hold up. Had to add a couple of screws to hold it in place and keep it from falling. Best advice is drill a couple holes and secure it in place unless you only travel smooth highways.

Absolute junk. Source box is far from even water resistant and the switch box doesn’t sit remotely flush when mounted.