Sink Undermount Installation Kit - 36"

This worked PERFECTLY. Very thick metal that stabilized the sink perfectly. High quality.

easy to install, some cuts may be needed but easy to do, works great

This made installation of our farmhouse sink so easy. Highly recommend!

A must have if your going with a under mount sink. This product is sturdy and adjust to pretty much any sink choice. I installed it after everything was already installed because previous unrelated mount failed.

My contractor installed this so I can't comment on installation but it was easy to shorten, doesn't take up much room in the cabinet and supports the giant cast iron sink I bought magically. The sink I used it for is the 33" Kohler riverby.

When tightening, the aluminum bars simply bend. There did seem to be a decent amount of upwards force being applied to the sink, but I expected more rigid bars.

Had to cut to fit into the cabinet, but exactly what I was looking for to mount my Stainless Steel Under Mount Sink.

The drawer slides were very tricky to mount and you need to be very precise with your measurements. However when sliding the drawers into place to ensure proper fit even gently two of the plastic tabs that secure the rail to the slide snapped, which meant we were only able to use 4 pairs instead of 5. The drawer slides that are installed are heavy and it is difficult to pull them out, but they are loosening up with use. Good soft close feature.

Installed under a Kohler 8206-CM1 which is 33-1/2" x 18-5/16" x 10-1/8" and 33 lbs. has held it up all summer. Screws went into existing wood frame. Only complaint is we used a power drill on the screws and have stripped some of the drive head. Recommend using a hand screwdriver to avoid this. The instructions probably also recommended this but oh well.

While I feel the design of this product could do the intended job, I have reservations about the materials used. There is A LOT of flex with the 36 inch aluminum bars that were cut down to fit the internal dimensions of the cabinet. This flexibility made setting the support screws a chore, going back and forth to have all the screws share the load equally. If one screw deflects the bar, other screws will no longer carry any load. The mounting brackets that hang from the cabinet wouldn't have been an issue if I had this product in hand before the countertops were installed. I used an oscillating tool to cut a recess for the brackets. The product was so flexible that I ended up buying another product to use in addition to this one. Over kill but its my time and peace of mind.