Invisible Ring Size Adjuster for Loose Rings Ring Adjuster Fit Any Rings, Assorted Sizes of Ring Sizer

This is a review and comparison of two different products:Feramox Invisible Ring Size Adjuster, assorted sizes (this product), and the Vancool (18pcs) Ring Size Adjuster (1.5mm/2mm/3mm) (https://amazon.com/gp/product/B073J4X9DH).I have several rings that were a little too loose and kept spinning around on my finger. I didn’t want to have them resized, because then they’d be too tight to go over my knuckle, so I decided to try some ring sizer products to see how well they worked.Bottom line: Overall I prefer the Feramox insert-type adjusters to the Vancool coil-type adjusters because of the look and comfort, but it all depends on your preference. Either type can be put in place after the ring is on your finger, so you don’t have to worry about getting the ring over your knuckle. The biggest drawbacks to the Feramox ones are that they may fall off and get lost if you don’t use the adhesive (and maybe even if you do), and you may only be able to use one size out of the package for a particular ring. The coil-type has the advantage of allowing you to adjust the ring size a little better by using thicker or thinner coils, and they won’t fall off.Detailed comparison:The Feramox adjusters, which were sold by “Freeman Direct”, come in a package of 8 in various sizes, to fit band widths from 1mm to 10mm. (They also sell packages for wider widths, so be careful what you order. If you are looking for sizers for thin rings like solitaires, this is the one you need.) Also included in the package are a silver polishing cloth and a sheet of adhesive. Unfortunately, the product information sheet comes attached to the adhesive sheet, so I didn’t realize what it was at first. There was a blue-green card that had the Feramox product information on one side, and a yellow backing on the other. The yellow backing was actually the backing for the adhesive tape sheet. I had to peel the Feramox card off it, which revealed the instructions for using the tape on the other side. The tape has a transparent film on one side, and the yellow paper sheet on the other. When you pull them apart, be sure to peel the Feramox card off, leaving the transparent film attached to the yellow sheet. Do not peel off the yellow sheet. If you choose to use the adhesive, cut a sliver of the tape to fit inside the groove in the ring adjuster. Peel off the yellow paper and attach the adhesive to the adjuster, then peel off the transparent film. I will probably not use the tape, because with the sizer stuck onto the band, I probably wouldn’t be able to fit the ring over my knuckle. Instead, I’m going to try wearing it by just slipping the sizer in place after the ring is on my finger. I’ll have to be careful not to lose it when removing the rings, but I think it will probably work out better for me, and none of the rings I’ll use it with will get daily wear.I found one sizer that perfectly snapped onto a 5.7mm gold band. The smallest sizer snapped onto a ring that was 2.16mm wide and stayed on. For the rings that are 1.25mm and 1.83mm, the smallest sizer wouldn’t stay on the ring by itself, but it seems to work okay on them if I slide them on once the ring is on my finger.Once in place, they’re virtually unnoticeable. The sizer is barely visible when looking at the palm side of my hand, and I don’t feel anything unusual except that the ring just feels a little thicker. It works great to keep the stone on the top of my finger where it should be, instead of sliding around.Unfortunately, you have to purchase a package of 8 different sizes, when you might only need one or two of the sizes. I wish they had packages of just one particular size, then I wouldn’t worry about losing one. On the other hand, I was able to use 3 of the sizes in this package, and since I’m not going to use the tape to stick them on the rings, I can move the smallest one between the rings that need it. You can use a sizer that’s a little wider than the band, so the two smallest sizes both worked for 3 different ring sizes.One other thing to note: When trying to get the rings on/off my finger with the insert in place, I found it a little more difficult than when using the coil type. Maybe it’s because the coil rolls around the ring, and helps the ring sort of roll over your finger. So if you do tape the insert in place, that might be an issue.Vancool Adjusters: This product was sold by “Nest My Life”. It comes with 18 adjusters (6 each of 1.5mm, 2mm, and 3mm coils, and also includes a polishing cloth. The adjusters are easy to use, just coil the desired size around the ring and cut it to desired length. I looked at a lot of similar products, but purchased this one because it included the smallest coils (down to 1.5mm). Most other packages did not come in a size less than 3mm. On a thin ring, the smaller coils look much better.The advantages of the coil adjusters are that you can use whichever thickness provides the best adjustment, and you don’t have to worry about them falling off the ring. You get so many of them, and only need a small piece for each ring, that it’s not a big deal if you need to replace them. Since the coils wrap around the ring, you don’t have to worry about them falling off. I also found that rings with the coil adjuster were easier to slide over my knuckle than rings with the insert adjuster, because the coils rolled and helped the ring move. But if you do have a problem getting the ring over your knuckle, it’s possible to put the coil on while the ring is on your finger.The downside is that they’re much more visible than the inserts, and are a little less comfortable. They also seem to slide around on the ring, which wasn’t a problem with the inserts.

Exactly what I needed!My ring has gotten so loose it could fall off. For one reason or another I don’t want to do a resize just yet.One of the included sizes easily attached to my (fairly large) ring. My ring now fits securely but is still very reasonable to remove.I’m very impressed with how subtle the adjuster is, too. It’s really hard to tell it’s there.This was the perfect product for my use case.Photos are how the ring fit before, how the ring looks with the adjuster attached, and how the ring fits after.

Very comfortable to wear. They can be a little difficult to attach but once it does it stays in place. I just got them so I’m not sure if they’ll discolor over time. I have bought several types of adjusters before I got these and these are the best yet. I like that they come in assorted sizes but wish there were two of each size.

I have a beautiful ring that belonged to my mom. It was big enough that I didn't wear it for fear that it would fall right off. When I saw these ring guards on Amazon, I knew they were the answer to the problem. They are easy to slip onto the inside of any ring and gave me a sense of security when I wanted to wear my mom's ring.!

The package says 8 pieces and there were only 6. I did use the ones I received so that’s fine but it was short. I used a them on 2 rings and they seem to work well. They stay put and are comfortable

Love that it comes with different sizes, guarantees a fit! Easy to put on and take off if/when needed. Saved me from having to pay $$ to get my rings resides againnn due to weight loss/ gain or even swelling. They are nice and smooth and discrete. It does get lotion in it but easy to pop off and clean! Quick fix to a ring sizing issue.

I’d give 10 stars if I could. This is so perfect. I recently got engaged and my ring was a bit big, I’m planning on getting it resized but I’m waiting because I’m currently on a weight loss journey and I don’t want to get it resized until I’ve reached my goal weight, and these have been truly amazing! They stay in place and don’t move around at all. Couldn’t be happier with this purchase.

I bought this based on other reviews for two of my rings that are about 1/2 size too big. Out of the 8 different sizes provided, two of them fit great on my rings because they are two different band widths. One is an eternity ring and the other is a channel set ring. You snap the sizer inside the ring - it did take some effort for the eternity ring to adjust it. Once the sizer is on, it is very comfortable and not noticeable.